V-LEDS Project Scion iQ Auxiliary Brake LEDs

Posted: February 22, 2012 in How to:, Products, Project Vehicles
Tags: , , , , , , , ,

We are on the second lighting mod on our Scion iQ. On the rear bumper there are 2 circular reflectors. They looked a little out of place but are required by DOT for visibility. We looked at them and thought “these would be great if they were active”. So we decided to see if they could be dissected and turned into brake lights.

Here we see the reflectors with as they appear from the factory.

We started by accessing the back of the reflector. This was pretty easy, with the removal of few plastic snaps we were able to remove the small rear inner fender liner. This allowed easy access to the fastener that holds the reflector to the bumper. After removing the nut from the backside of the reflector it comes right out.

Behind the bumper you can see how the reflector mounts. You can also see the wiring for the LEDs.

The red reflector portion of this unit is plastic welded to the mount (backer). There is enough space inside to hold one V-LEDS STRIP_RL_12_R. To separate the red reflector from the backer we heated a razor knife and pressed it into the seam where the front and back are fused together. Then it was just a matter of wedging a small flat blade screw driver into the melted section and prying them apart. It is not a clean split, but is the most non-invasive way to get it apart so that they can be glued back together later.

After you separate the front and back its time to get them ready for the STRIP_RL_12_R to be installed. I oriented the LED disc so the pattern of LEDs was aligned so the vertically/horizontally. From there I drilled a hole for the wire to be routed through. I drilled a hole in the bumper so the wire could be routed through as well.

LED Installed Inside Rear Reflector.

Here are the reflectors after completion.

After affixing the LED we used super glue to reattach the reflector to the backer. It was a tight squeeze but it fit inside. After the glue cured we reinstalled them and routed the wiring through a factory rubber grommet located on the back of the car. We ran the wiring up to the factory brake lights and spliced it into the brake circuit.

Reflectors are now active brake lights.

Here is a list of all the components used on this upgrade:

2 of these: STRIP_RL_12_R

2 of these: DIY2_WIRE_48

1 of these: DIY2_Y_ADAPT

Thanks for reading. If you have questions regarding this product please send an email to our customer service department at sales@v-leds.com. We are quick to respond via email and can answer any questions you may have about our products.

Here are some more photos of our Scion iQ.

Comments
  1. Rodney says:

    The looks good. Can you make them for the Kia Soul?

  2. V-LEDS says:

    If your car has a similar setup to the IQ you could use our LEDs to create a similar setup. We only supply the LED parts, they need to me installed by yourself or a vehicle customization shop.