Using an HID HARNESS with any V-HIDS Single Beam HID Kit

Posted: December 9, 2010 in How to:, Products, Technical
Tags: , , , ,

Are you wondering how to use the HID Harness with your V-HIDS headlight conversion kit? I want to cover a cool feature that comes standard with every “single beam” V-HIDS kit we offer. This feature allows for quick plug-n-play installation of the HID Harness and other accessories your car may need.

H11 HID bulb and Input Adapter Jumper

The feature that I am talking about is what I refer to as the “Input Adapter Jumper”. The picture to the right shows the jumper wires as they come in the kit, attached to the HID bulb. They are routed through a rubber grommet with the HID bulbs wiring. This is so you can route them into your headlight housing and keep a water tight seal if you have sealed-back headlights. This input adapter jumper has as a male 9006 connector on one end and the specific end of the bulb type of the kit on the other end, this one happens to be an H11. This allows for a direct connection from your cars headlight socket to the input connector of the HID harness.

Connection of the Adapter to the HID Harness

Input Connector of the HID Harness

The HID Harness has a single input connector shown here. It is a female 9006 plug. This is where you connect the adapter to the HID Harness. Here is another bonus to this setup. If your car is equipped with a warning light that indicates you have a burnt out headlight and you need to install an inline capacitor or inline resistor you’re in luck. These parts come with male and female 9006 connectors too. So if you need any additional parts to get your V-HIDS kit working they will plug right into this setup without any modification to your cars wiring harness.

9006_INLINE_RES INLINE_CAP_ADAPT 9006_DRL_MODULE

9006_INLINE_RES INLINE_CAP_ADAPT 9006_DRL_MODULE

Here we see the 9006_INLINE_RES,   INLINE_CAP_ADAPT and the 9006_DRL_MODULE. Each one is designed for different applications. I will be covering these applications in the future. In the following pictures you can see how easy it is to install them inline. Using the 9006 style connectors allows adding these parts to this setup to be quick and easy. A complete wiring schematic for the HID_HARNESS is at the bottom of the page too.

9006_INLINE_RES Installed

If you do have any application questions feel free to ask. You can email me direct at: tech@v-leds.com

INLINE_CAP_ADAPT Installed

Thanks for reading, James the tech@v-leds.com

Here are links to other articles that contain additional information on some of these products:

HID_HARNESS

DRL_MODULES

9006_DRL_MODULE Installed

Installation Diagram For HID_HARNESS

Installation Diagram For HID_HARNESS

Comments are closed.